Fanimation The Crestford FP7954OB El Manual Del Propietario página 9

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

How to Assemble the Blades and Light Plate Assembly(continued)
4. Secure the blade holders to the flywheel using the
#10-32 x 3/8˝ screws through the holes located on the
bottom of the flywheel. (Figure 20)
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
5. Remove one of the three screws in the motor
assembly. Slightly loosen the remaining two screws.
Assemble the adapter-switch housing to the motor
assembly using the two key slots. Replace the third
screw and securely tighten all three screws.
(Figure 21)
6. Securely attach the 4-pin switch cup connector
to the wiring harness switch housing within the
light kit assembly. (Figure 22)
7. Remove one of the three screws in the adapter-
switch housng. Slightly loosen the remaining two
screws. Assemble the light kit assembly to the
adapter-switch housng using the two key slots.
Replace the third screw and securely tighten all three
screws. (Figure 23)
WARNING
Flywheel
HARDWARE USED:
#10-32 x 3/8˝
SCREWS
Motor
Assembly
Adapter-Switch
housing
Adapter-Switch
housing
9
Blade Holder
#10-32 x 3/8˝ Screws
Figure 20
(2 per assembly)
x 10
Figure 21
Figure 22
Light Kit
Assembly
Figure 23

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido