Maintenance; Sharpening The Blades - Nogueira EN-9F3B Manual De Instrucciones

Maintenance

Your NOGUEIRA ENSILING MACHINE requires a minimum amount of maintenance in order to
achieve perfect operation and maximum durability. Therefore, the following are some important
maintenance measures:
- Clean the machine routinely.
- Keep the machine properly lubricated.
- Replace worn or damaged parts.
- Keep the belts in good condition and properly stretched.
During the first hours of operation, retighten all the fastening screws and verify the tightness of the
belts.
Before performing any maintenance, adjustment, or lubrication job, disconnect
the motor from the electricity network (in tractor actuation models, remove the key
from the ignition).
Wait for all the components to be motionless, before touching any part of the
machine.
CAUTION
Use the same specifications as the original when replacing screws and nuts.
When handling blades, be careful not to get hurt by the cutting edge.
Reinstall all the protective covers before turning on the machine.

Sharpening the blades

It is essential for the blades to be well-sharpened and adjusted to the counter-blades, in order to
achieve good quality and efficient cutting. The blades must be check daily and sharpened whenever
necessary.
When the machine is turned off, open the housing cover and check all the blades and when
necessary:
1- Remove all the rotor blades.
2- Then proceed by sharpening all the blades. Keep the same cutting edge angle as the original and
remove the same amount of material on each blade, as to not affect the rotor balancing.
Model: EN-6180
24
BLADE
fig.45
Instruction manual
Other models
BLADE
fig.46