Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Figure 30. Installing the intrusion switch module
Next steps
1. Reconnect all the cables to the power interposer board (PIB).
2. Follow the procedure listed in
Unidades
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
NOTE:
The procedure to remove the drive blank is the same for Rear Accessed and Front Accessed configurations.
Steps
Press the release button, and slide the drive blank out of the drive slot.
Figure 31. Removing a drive blank
42
Instalación y extracción de componentes del sistema
After working inside your
Safety
instructions.
bezel.
system.
Tabla de contenido
