Removing M.2 Ssd Module; Installing M.2 Ssd Module - Dell EMC PowerEdge XR11 Manual Del Usuario

Removing M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the BOSS S1
NOTE: The procedure to remove the M.2 SSD module is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Using the Phillips 1 screwdriver, remove the screw securing the M.2 SSD module to the BOSS S1 card.
2. Pull the M.2 SSD module to disconnect from the connector on the BOSS S1 card.
Figure 78. Removing the M.2 SSD module
Next steps
If applicable, install the M.2 SSD

Installing M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the BOSS S1
NOTE: The procedure to install the M.2 SSD module is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Align the M.2 SSD module at an angle with the connector on the BOSS S1 card.
2. Insert the M.2 SSD module until it is firmly seated in BOSS S1 card connector.
3. Using the Phillips 1 screwdriver, secure the M.2 SSD module on the BOSS S1 card with the screw.
NOTE: Los números de la imagen no muestran los pasos exactos. Los números son solo para la representación de la
secuencia.
Safety
Antes de trabajar en el interior de su
card.
module.
Safety
Before working inside your
card.
instructions.
equipo.
instructions.
system.
Instalación y extracción de componentes del sistema 83