Worx WU430 Manual Del Usuario página 10

SYMBOLS
Read the manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
10
Circular saw
13L-WU430-M-070305¸ÄFÓïCE´¦.indd 10
OPERATING INSTRUCTIONS
1. SAFETY ON/OFF SWITCH
Your switch is locked off to prevent accidental
starting. Depress lock off button (8) then on/off
switch (1) and release lock off button (8).Your
switch is now on.To switch off just release the
on/off switch.
2. HAND GRIP POSITION
Always hold your saw firmly with both hands
when operating.The right and wrong ways to
support large workpieces are shown in Figures
A and B.
3. FITTING AND CHANGING A SAW
BLADE
Warning: Your circular saw has been
shipped completely assembled,
except for the blade, which is packed
unassembled. Before fitting you must
inspect the saw blade carefully to make
sure that no breakage or damage has
occurred during shipping.
Press the spindle lock button (9), and use the
Spanner (12) provided to remove the blade
bolt (15) and outer flange (16). Rotate lower
blade guard (4) clockwise and hold open using
the lower blade guard lever (5) whilst changing
the saw blade (6). Ensure the blade bore is
located on the inner flange (14) and the blade
direction arrow points in the same direction
as the lower blade guard (4) arrow. Check the
blade surface and flanges are clean. Press the
spindle lock (9) again and re-fit the outer flange
(16) over spindle (17) flat and tighten the bolt
with 1/4 turn more than finger tight. Check the
blade is securely clamped.
Warning: Blade teeth are very sharp.
For best cutting results ensure you use
a saw blade suited to the material and cut
quality you need.
4. DEPTH OF CUT ADJUSTMENT
Lift the depth of cut locking lever (10) and raise
the saw body away from the base plate (3).
Set the depth of cut using the scale (11) and
push the lever (10) down to lock (See C and D).
Always add 3mm to your depth of cut so the
blade can cut through the material.
ENG
3/5/2007 5:02:58 PM