Additional Safety Instructions For Grinding With Wire Brush; Turner Safety Instructions; Emission Levels - Protool RGP 150-16 E Manual Original / Lista De Piezas De Repuesto

5.6 Additional safety instructions
for grinding with wire brush
Safety warnings specifi c for grinding
with wire brush
a) Be aware that even during common
working activity wire bristles are
thrown off the brush. Do not overload
the wires by excessive loading of the
brush. Wire bristles may easily penetrate
through thin clothes and/or skin.
b) If use of protective guard is recom-
mended for grinding with wire brush,
make sure there is no contact between
the wire disc or the brush and the pro-
tective guard. The wire disk or brush may
enlarge its diameter during operation, due
to load and centrifugal forces.

5.7 Turner safety instructions

► The machine may not be used in damp
and wet spaces, outdoor when it is rainy,
foggy or snowy or in the explosive envi-
ronment.
► Before use always inspect the fl exible
lead and the plug. Have the defects re-
paired by a specialist repair shop.
► Outside the premise use only approved
extension leads and cable connections.
► Apply the machine to the material only
when switched on.
► Do not carry the machine by the lead.
► Do not work on a ladder.
► When operating the tool, use protective
gloves and tough footwear.
► When operating the tool, use goggles and
ear protectors.
► The dust generated during work is harm-
ful to health. When operating the tool,
use the dust extraction system and the
respirator.
► Materials containing asbestos are not al-
lowed to mill.
► Flexible power supply cable always route
from the tool backwards.
► Only use milling rings recommended by
the manufacturer.
► Plug in the fl exible power supply cable's
plug into the wall socket when the ma-
chine is off.
20
► Make yourself sure whether the material
that is going to be machined does not
contain electric, water or gas lines – an
injury could occur.
► Do not mill over metal objects, nails or
screws.
► The machine is not allowed to be operat-
ed by a person under 16 years of age.

5.8 Emission levels

Levels determined in accordance with
EN 60 745 are typically:
Sound pressure level
Noise level
Uncertainty
CAUTION
Operating noise
Damage to hearing
► Use ear protection!
Vibration emission value a
three directions) and uncertainty K meas-
ured in accordance with EN 60 745:
Milling with milling head
Grinding with grinding
wheel
The emission values specifi ed (vibration,
noise) were measured in accordance with
the test conditions stipulated in EN 60 745
and are intended for machine comparisons.
They are also used for making preliminary
estimates regarding vibration and noise
loads during operation.
The emission values specifi ed refer to the
main applications for which the power tool
is used. If the electric power tool is used for
other applications, with other tools or is not
maintained suffi ciently prior to operation,
however, the vibration and noise load may
be higher when the tool is used.
Take into account any machine idling times
and downtimes to estimate these values
more accurately for a specifi ed time period.
This may signifi cantly reduce the load dur-
ing the machine operating period.
L = 89 dB (A)
PA
L = 100 dB (A)
WA
K = 3 dB
(vector sum for
h
a < 4.0 m/s
2
h
K = 1.5 m/s
2
a < 2.6 m/s
2
h
K = 1.5 m/s
2