System Wiring Fault Diagnosis; Travel Path Learning - Vimar Elvox FRAGMA 3D ZBNC Manual Para El Conexionado Y El Uso

FRAGMA
The main menu is used to set the numerical values of each function and to activate or deactivate a function.
DIsPLAY
LRNE
RAD
LRN
PAR
DEF
CNT
To enter the main menu:
1. Press either the "UP ARROW" or "DOWN ARROW" button to enter the menu and browse the items.
2. Press "OK" to access the various submenus.
3. Press "ESC" to switch off the display or return to the power supply view, if running on batteries (optional).
Note: before switching off automatically, the display remains on for 10 seconds after the last operation if displaying the battery power supply (optional),
otherwise for 2 minutes if displaying any other menu. Pressing any button restarts the timeout counter from zero.

TRAvEL PATH LEARNING

Before starting the travel learning procedure, open the arm by about 10 cm.
1. EAsY LEARNING (LRNE)
Press either the "UP ARROW" or "DOWN ARROW" button until the "LRNE" item appears and then press "OK" to start the travel path easy self-learning
procedure.
Pressing the "OP/CL" button, located in the top right-hand part of the board, executes the travel path learning procedure in fully automatic mode.
The opening and closing slow-down points are set by default to 70% and 30% of the total travel. Automatic closing is set to 60 seconds.
All parameters can be modified manually if required (see "Parameter programming").
Note: during the Easy Learning procedure (LRNE), slow-down does not occur during the first opening manoeuvre.
2. NORMAL LEARNING (LRN)
Press either the "UP ARROW" or "DOWN ARROW" button until the "LRN" item appears and then press "OK" to start the travel path self-learning procedure.
The following table describes the steps of the procedure:
DIsPLAY
APCH
CLS
OPN
SLO
CLS
SLO
END
ERR
Note: you can interrupt the learning procedure at any time by pressing the "ESC" button and the "ERR" message will be displayed.
Note: if at the start of the procedure the "OP/CL" button is not pressed within 10 seconds, learning mode will exit and the "ERR" message will be displayed.
EN
MEANING
Starts the gate manoeuvre Easy Learning procedure. See the section "Travel path learning"
For storing the radio controls. See the section "Radio controls programming"
For starting the gate manoeuvre learning procedure. See the section "Travel path learning"
For setting the learning parameters. See section "Parameter programming"
For restoring the default learning parameter values. See section "Parameter programming – Restoring the
default values"
Displays the total counter and partial counter which record the number of opening cycles performed by the
appliance. See the "Counters" section
MEANING
Activate the OPEN/CLOSE input (including on radio control, if configured). Starts the closing movement
Start of closure, wait until the gate reaches the closed position. It is also possible to stop the movement of the gate
at the desired point by activating OPEN/CLOSE
Opening control. Activate OPEN/CLOSE to set the point at which the opening slow-down must start
Opening slow-down, wait for the gate to reach the fully open position or activate OPEN/CLOSE to fix the point at
which the automation is considered open
Closing control. Activate OPEN/CLOSE to set the point at which the closing slow-down must begin
Closing slow-down, wait for the gate to reach the fully closed position or activate OPEN/CLOSE to fix the point at
which the automation is considered closed
Procedure successfully completed. The parameters are stored in the memory. To see them and modify them ma-
nually see the section "Parameter programming".
Message that may be displayed at any time. It means that the procedure has been interrupted before completion, no
learned parameter is saved in the memory. Reactivate the procedure.
21