Vacuum-Steam - ARIETE Vapori aspira Manual De Instrucciones

Fit the brush onto the frame, press it in fully and lock it into
place by turning the two side tabs (E) into the locking position
( ).
In the same way, to remove the frame, release the brush by
turning the tabs to the position (
WARNING: This frame (H) must only be used on dry
floors and surfaces.
3.2

VACUUM-STEAM

Multipurpose brush (D)
With this brush, it is possible to vacuum dust and liquids as well as to dispense steam.
It is recommended for use on large surfaces, ceramic floorings, marble, parquet, rugs, etc.
According to the type of surface to be cleaned, fit the following frames:
- bristled frame (F), which is suitable for steam cleaning resistant surfaces;
- wet vacuum frame (G), which is suitable for removing liquids from smooth surfaces;
- soft-bristled brush (I), which is suitable for vacuuming any type of surface;
- frame (L) for cleaning carpets and rugs.
Before fitting one of the frames mentioned above (F,G,I,L), move the two tabs (E) to the release
position, as described in paragraph 3.1.
To fit the different frames to the brush (D), place the brush on
the frame, press it in fully and lock it into place by turning the
two side tabs (E) into the locking position (
In the same way, to remove the frame, release the brush by
turning the tabs into the position (
CAUTION: To avoid the risk of dropping parts acci-
dentally and damaging them, this operation should
be performed on a flat surface.
CAUTION: If the tabs should come away from their
seating, refit them, pressing down as shown in para-
graph 3.1.
The multipurpose brush can be connected to the nozzle (A)
using one or both extension tubes (C), or it can be inserted
directly onto the handle (A6).
To lock or release this attachment on the tubes or handle, it is
necessary to turn the clip (B) after inserting the attachment on
the relevant coupling point.
).
).
).
31