Edge Cleaning Bristles; Troubleshooting - Hoover CH53000 Manual Del Propietário

edGe CleaninG BRistles: ReMoVal & RePlaCeMent
to rePlAce edGe cleAninG Bristles
Caution
!
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
4.13 Remove two (2)
screws from each
edge cleaning bristle.
4.14 Remove and
dispose of old
bristles and replace
with new bristles on
each side.
4.15 Replace all four
(4) screws to secure.
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a sevice center prior to continuing use.
To reduce risk of personal injury - Unplug before cleaning or servicing
PRoBleM
Cleaner won't run
Cleaner/ tools
won't pick up or
low suction
Dust escaping
from vacuum
To reduce the risk of injury from moving parts - Unplug cleaner
!
before servicing.
4.13
what to Buy: Bristle
Use only genuine Hoover
please call 1-800-944-9200 or visit hoover.com.

5. tRouBlesHootinG

waRninG
!
PossiBle Reason
1. Not firmly plugged in.
2. No voltage in wall receptacle.
3. Blown fuse or tripped breaker.
4. Thermal protector activated .
1. Paper bag not installed
correctly.
2. Filter bag full and/or clogged.
3. Brushroll worn.
4. Broken or worn belt.
1. Bag full.
2. Filter bag not installed
correctly.
4.14
bristles with your vacuum. For bristle replacements,
®
!
PossiBle solution
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse or reset breaker in home.
4. Unplug and allow cleaner to cool for 30
minutes (this will reset the thermal protector).
1. Review paper bag removal and replacement.
2. Change filter
3. Replace brushroll.
4. Replace belt.
1. Change filter bag.
2. Review filter bag removal and replacement-
page.
9
4.15
bag.