Acoem OneProd Eagle Manual Del Usuario página 9

4. P
OWER OVER
PoE is the power supply.
The PoE power supply is the main disconnecting device in the system and, as such,
should remain always perfectly accessible and disconnectable. Alternatively, a switch
on the power supply line, permanently accessible, can also constitute the main
disconnecting device.
Only use the PoE injector sold or recommended by ONEPROD to power up the gateway.
The PoE injector is fully compliant with IEEE802.3.af.
Outputs are equipped with short-circuit protection and overload protection as per IEEE 802.3af
specification.
Only use the power cord adapted to your country.
5. ETHERNET CABLE
Electrical Specifications:
Use an Ethernet Class D / Cat. 5E Connection Type 10 BaseT, 100 BaseT BaseTX or 1000
cable for industrial environment.
Environment:
The cable must at minimum be provided for a range of temperature: -20°C to +60°C
The diameter of the cable must be adapted to the cable gland RJF544 connector to preserve
the seal and stowage (minimum section 6 mm).
The cable must be resistant to its environment. In particular, to the different possible pollution
(oil, grease, oil, chemicals, humidity, etc.)
The cable must be moisture resistant
Outdoor use:
If the cable is used outdoors, it should be resistant to UV (ultraviolet light).
Protection:
The cable must be protected from impact. If exposed, it must be reinforced.
The installer will check the cable compatibility with its environment with the site manager, in
both normal and accident conditions.
6. G
ENERAL
6.1. D
EVICES INTEGRITY





6.2. M
AINTENANCE




E
THERNET
Before use, check the integrity of devices, cables and accessories.
Check that enclosures are not cracked, broken or abnormally distorted.
Check the condition of the opening plug of the Ethernet port of the gateway.
Check that sensors and expanders are tightened.
In case of a defect, have the defective part(s) replaced. Disconnect the power of
the Gateway.
,
SERVICE AND MODIFICATIONS
Service operations are prohibited by persons other than ONEPROD staff.
Only the battery replacement may be performed by the end user.
It is forbidden to make any changes to the products. Any change will cause the
loss of all compliance certifications for this product.
It is strictly forbidden to open gateway's enclosure.
9
Brand of ACOEM