Fcc Notes - Acoem OneProd Eagle Manual Del Usuario

6.4. FCC IC
AND
6.4.1. Agreement numbers
Item
Gateway (Int. Antenna)
Single-Axis Sensor
Tri-axial Sensor
Expander
Caution: any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
6.4.2.

FCC NOTES

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception which can be determined by turning
the equipment off and on, the user is encouraged to try to correct interference by one or more
of the following measures:




RF exposure: This device complies with FCC RF radiation exposure limits set forth for general
population. This device must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
6.4.3. IC NOTES
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.


RF exposure: This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Table 5: FCC and IC IDs for EAGLE devices
Model
EGL1101000
EGL1102000
EGL1103000
EGL1104000
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The antenna sensors and repeaters are internal and not interchangeable.
The antenna of Gateway EGL1101000 is internal and not interchangeable.
FCC ID (USA) IC (Canada)
2AC3Z-EGL1101 12336A- EGL1101
2AC3Z-EGL1102 12336A-EGL1102
11
Brand of ACOEM