Ryobi RBC30SESB Manual De Utilización página 69

Insert one end of the string into the eyelet located
■
on the side of the string head and push until string
comes out through eyelet on the other side. Continue
to push string through the string head until the middle
section of the string is inside the string head and
string outside the string head is evenly divided on
each side.
Rotate the knob on the string head clockwise to wind
■
the string.
Wind the string until approximately 20cm remains
■
protruding from the string head.
BLADE PROTECTOR (Fig. 10)
Always place the blade protector on the blade when the
unit is not in use. The blade protector has clips round the
edges to snap over the blade and keep it in place. Wear
gloves and be cautious when handling the blade.
NOTE: Always remove the blade protector before
using the unit. If not removed, the blade protector could
become a thrown object as the blade begins to turn.
CLEANING THE EXHAUST PORT AND
SILENCER
Depending on the type of fuel used, the type and amount
of lubricant used, and/or your operating conditions, the
exhaust port and silencer may become blocked with
carbon deposits. If you notice a power loss with your
petrol powered tool, a qualified service technician will
need to remove these deposits to restore performance.
SPARK ARRESTOR
It is recommended to clean or replace the spark arrestor
every 25 hours to ensure proper performance of your
product. Spark arrestors may be in different locations
depending on the model purchased. Please contact
your nearest service dealer for the location of the spark
arrestor for your model.
ATTACHING THE HANGER CAP (Fig. 11)
To use the hanger cap, push in the button and place the
hanger cap over the lower end of the attachment. Slightly
rotate the cap from side to side until the button locks into
place.
NOTE: The secondary hole in the attachment shaft can
be used for hanging purposes as well.
CLEANING THE AIR FILTER SCREEN (Fig. 12)
For proper performance and longer life, keep the air filter
screen clean.
Remove the air filter cover by pushing down the latch
■
while gently pulling out the cover.
Brush the air filter screen lightly.
■
English (Original instructions)
■
FUEL CAP
SPARK PLUG (Fig. 13)
This engine uses a Champion RCJ-6Y or equivalent
spark plug with 0.63 mm electrode gap. Use an exact
replacement.
STORAGE (1 MONTH OR LONGER)
■
■
■
20
Replace the air filter cover by inserting the tabs of the
cover into the slots on the air filter base, then push
the cover up until it latches securely in place.
WARNING
A leaking fuel cap is a fire hazard and must be
replaced immediately.
Drain all fuel from tank into a container approved
for fuel. Run engine until it stops.
Clean all foreign material from the trimmer. Store it in
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Abide by all ISO and local regulations for the safe
storage and handling of fuel. Excess fuel should be
used up in other 2-stroke engine powered equipment.