Operation And Functions; Setting Pushbutton; Blinking Codes; Start Menu - Resol Solex Manual De Instrucciones

SOLEX
2. Operation and function
2.1

Setting pushbutton

operating control
lamp
(-) backward
2
SET / OK
(selection/ adjustment mode)
2.2

Blinking codes

2.3 Start menu

2.4 Adjustment for the operation with a solar cell
forward (+)
1
3
The controller is operated by three pushbuttons below the
display. Button 1 is for scrolling forward through the menu
options or for increasing the adjustment values. Button 2
is used for the opposite function.
Button 3 is for the adjustment of individual parameters.
By pressing button 3 you will get to the next submenu or
the SET-mode. It is also used for the confirmation of the
adjustments made.
In order to get to the main menu the backward button has
to be set to „back" and has to be confirmed with the SET
/ OK button. If no button has been pressed for more than
60 seconds, the controller is automatically set back to the
main menu.
Important notice: The selectable values and options are
function dependant and will only appear on the display if
they are available for the adjusted start parameter and are
activated via the operation code.
Operator code: Expert-Code 077
All menues and adjustable valued are indicated and all ad-
justments can be changed.
Constantly green:
Blinking red/green:
Blinking green:
Blinking red:
When switching on the controller for the first time, a spe-
cial Solex type menu will be displayed. In this menu the sys-
tem type can be feeded in (HF 20, HF 30, LF 21 oder LF 45).
You can leave the menu without making any adjustments.
As long as the der Solex type isn't specified the solar cycle
will be blocked. When the time-out is over the controller
will get back to the Solex type start menu. If the Solex type
has been specified - this menu won't be activated again. A
correction of the system type can be carried out by expert
adjustable values.
(expert/Adj. values/Flow Set)
1. Adjust the CS10-type for the solar cell
(expert/Sensors/CS-type).
2. Activate the CS10 adjustment for the solar cell
(expert/Sensors/CS-adjust).
The solar cell has to be branched off for this purpose!
3. Activate the CS10-Offset for the solar cell
(expert/CS-offset/cs-offset).
The solar cell has to be branched off for this purpose!
orderly operation
initilisation phase (10 sec.)
manual operation
sensor failure
23 |