Navodilo za uporabo
1. Nastavite stroj za šivanje 3-nitnega zvitega roba
1. Set the machine for a 3-thread rolled hem or 3-thread
flatlock (left needle for wider beads, right needle for
ali šivanje s 3-nitnimi ploščatimi šivi (leva igla za
smaller beads).
večje perle, desna igla za manjše perle).
2. Beads up to 5/32" (4 mm) diameter can be used.
2. Lahko uporabljate perle s premerom do 4 mm.
3. Adjust stitch length to suit beads and pearls.
3. Nastavite dolžino šiva, da bo primerna za
izbrane perle in bleščice.
4. Raise the presser foot and snap on "Beading and
Sequin foot"
4. Dvignite tačko in namestite tačko za
5. Place strand of beads/sequins in the guide (1) and (2)
okraševanje s perlami in bleščicami.
to the end of the foot.
5. Namestite nitko z nanizanimi perlami/bleščicami
6. Lower the foot, sew a few stitches to fix it.
v vodili (1) in (2) do konca tačke.
7. Place the fabric under the foot and sew.
6. Spustite tačko in naredite nekaj pritrdilnih šivov.
7. Namestite blago pod tačko in začnite s
8. Note: If the strand of beads is sewn onto the fabric
edge, cutting can be activated. If the strand of beads
šivanjem.
is sewn on with a flatlock, fold the fabric accordingly
8. Pozor! Za prišivanje perl na rob blaga lahko
and guide about 1.5 mm from the right of the needle,
aktivirate rezanje. Če za prišivanje uporabljate
it should penetrate the fabric edge. Cutting can be
ploščate šive, zložite blago na ustrezen način
deactivated if needed.
in usmerite 1,5 mm desno od igle, igla mora
prebadati rob blaga. Po potrebi izklopite
rezanje.
Tačka za okraševanje s perlami in bleščicami –
Beading and sequin foot – Instructions
Blago
Navodilo za uporabo
Perle
12
