Charging The Rechargeable Battery - Dräger UCF FireVista Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Error

Cause

LED in the charging cra-

Camera is not seated

dle indicates an error

correctly in the charging

during the charging pro-

cradle.

cess or nothing at all.

Contacts on the camera

and/or the charging cra-

dle are dirty.

Contacts on the camera

and/or the charging cra-

dle are damaged.

The retainer on the

charging cradle is not

closed.

No power supplied to the

charging cradle.

Maintenance

The following components of the thermal imaging camera in particular can be

replaced by DrägerService:

–

Rechargeable battery

–

Window of the IR camera

–

Display

Instructions for use

Dräger UCF FireVista

6.1

Remedy

The display and window of the IR camera consist of scratch-resistant material.

Check the position of the

Nevertheless, take care when cleaning these optical surfaces.

hand straps or the carry-

ing strap and correct if

NOTICE

necessary.

The camera housing could be damaged if solvents or thinners are used for

Remove foreign objects

cleaning.

from under the camera

► Do not use any solvents or thinners.

or in the charging cradle.

1. Wipe the thermal imaging camera with a damp, lint-free cloth. If necessary,

Place charging cradle on

clean with warm, soapy water.

level surface.

2. Dry the thermal imaging camera with a soft, lint-free cloth, and leave to dry

completely.

Clean the charging pins

on the camera and the

charging cradle.

6.2

If the charging pins are

defective, send the cam-

NOTICE

era and the charging

If the charging cradle comes into contact with water, there is a risk of a short

cradle to Dräger.

circuit.

Close the retainer.

► Make sure that the thermal imaging camera and the charging cradle are dry.

Charge the thermal imaging camera in ambient temperatures of 5 °C to

40 °C. The charger stops charging and indicates an error to prevent damage to

Check the functioning of

the rechargeable battery when temperatures are outside this range. The

the power supply unit

charger continues charging as soon as the camera temperature reaches the

and the connecting

permissible range again.

cable.

The thermal imaging camera can be returned to DrägerService when the

rechargeable battery can no longer be charged. DrägerService can change the

rechargeable battery.

1. Place the thermal imaging camera in the charging cradle. Close the retainer

on the charging cradle.

 The LED flashes green when the rechargeable battery in the thermal

 The LED lights green when the rechargeable battery in the thermal

 The LED rapidly flashes red if an error has occurred.

Cleaning the thermal imaging camera