Cycle Selection - Ghibli & Wirbel POWER STEAM 5.3 MI Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968

Cycle selection

The device has the ability to perform 3 cycles:
Only vacuum cycle
- Press the switch (34 Fig. 11) to "I" to start
the vacuum cleaner.
Press the switch (34 Fig. 11) to "0" to stop
the vacuum cleaner.
Only steam cycle
- Press the switch (33 Fig. 11), which lights
up,, on "I" to apply power to the water
heating elements.
- Wait until the set temperature is reached
indicated by the lighting of the switch (33
Fig. 11) and the lighting of the LED (30
Fig. 11).
NOTE:
The time needed to reach the set tempera-
ture is about 6 minutes.
- Press the lever (35 Fig. 11) to produce
steam; at the first distribution, air will
come out mixed with water; wait for the
restoration of the set temperature indicat-
ed by the lighting of the LED (30 Fig. 11).
- To stop the steam release the lever (35
Fig. 11).
Steam and suction cycle
- Press the switch (33 Fig. 11), which lights
up, to "I" to apply power to the water heat-
ing elements
- Wait until the set temperature is reached
which is indicated by the switch light
which turns off (33 Fig. 11) and the light-
ing of the LED (30 Fig. 11).
NOTE:
The time needed to reach the set tempera-
ture is about 6 minutes.
- Press the lever (35 Fig. 11) to deliver
steam; at the first distribution, air will
come out mixed with water; wait for the
restoration of the set temperature indicat-
ed by the lighting of the LED (30 Fig. 11).
- To stop the steam release the lever (35
Fig. 11).
- Press the switch (34 Fig. 11) to "I" to start
the vacuum cleaner.
Press the switch (34 Fig. 11) to "0" to stop
the vacuum cleaner.
Use as a vacuum cleaner
- Set the unit as described in the para-
graph "Suction cycle".
- Raise the head (38 Fig. 13) as described
in the relative paragraph.
- Check that the nylon filter (40 Fig. 13) and
the motor protection filter (39 Fig. 13) are
present, then refit the cylinder head.
- Install the appropriate accessories (rigid
extensions, floor nozzle with bristles,
nozzle for carpet, etc. ..) depending on
the type of use that you need.
- Proceed to clean as a normal vacuum
cleaner.
WARNING:
It is forbidden to use the appliance
without the motor protection filter (39 Fig.
13) being correctly mounted on the motor
cover.
NOTE:
When the recovery tank is full there is a
measurable decrease in suction; turn off the
unit and empty the tank as described in the
relevant paragraphs.
Use as a dry vacuum cleaner
- Set the unit as described in the para-
graph "Suction cycle".
- Raise the head (38 Fig. 13) as described
in the relative paragraph.
- And check that the nylon filter (40 Fig. 13)
and the motor protection filter (39 Fig. 13)
are present, then refit the cylinder head.
- Install the appropriate accessories (rigid
extensions, floor nozzle etc).
- Proceed to the intake of liquid from the
floor.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
ENGLISH - 5