Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LEGEND:
Item
N-L-PE
230 Volt power terminals
F
Fuse 5x20
FAN 1
230 Volt Power Supply - Supply fan V1
FAN 2
230 Volt Power Supply - Extraction fan V2
F1
0-10 Volt Signal - Fan V1
F2
0-10 Volt Signal - Fan V2
B1 - B4
Temperature sensors
CONTROL
T-EP wall-mounted controller
T-EP
DGTO
Digital output contact
C1-C1
NO dry input contact
C3-C3
NC dry input contact (active only if JUMPER MC4 is open)
FC-FC
SPST Dry output contact
IAQ
Internal Relative Humidity Sensor
RS485-A
Serial A network connection
RS485-B
Serial B network connection
MC3
Power board service jumper
MC5
Serial A network jumper
EH1
Electric duct Pre-Heating PWM control output
EH
DL1
Power on LED
KNX
KONNEX communication
DY1
Board display
KP1
" - " key
KP2
" ENTER " key
KP3
" + " key
PE MOTOR
EC motor earthing protection
***
B1
Fresh air temperature probe
B2
Supply air temperature probe
B3
Extracted stale air temperature probe
B4
Exhaust air temperature probe
CONTROL PANEL DETAILS
DY1
KP1
KP2
Description
Probes
F130 .
LED
KP3
/
/
/
/
/
/
***
see table below
OPTIONAL ( accessory not supplied with the unit)
Signal for external enabling or for controlling valves equipped with solid state
relay
trnF
• Remote On/Off "
" function – unit Off when the contact is closed
bSt
• Booster "
" function - Booster function active when the contact is closed.
See Fireplace and Boiler functions
Remote alarm or external enabling signal
/
SLAVE modbus port for connection to supervision Master devices.
SLAVE modbus port for connecting Master devices + 12V power supply
/
The network must be closed on the last unit in case of RS485 connection. It is
closed by closing Jumper MC5.
/
Signal necessary to detect the error status of the antifreeze element
/
Towards interface expansion board with KNX supervision systems
/
/
/
/
/
Notes
English
73
Tabla de contenido
