VIERLING VIT-A2 Manual De Instrucciones página 36

VIERLING
"Internet test" LED will begin flashing slowly. If the ADSL link is not yet
synchronized when you begin the test, the test will enter a waiting state
(indicated by slow, interrupted flashing of the "Internet test" LED). The test
will proceed once the ADSL connection is ready.
You can interrupt an ongoing test at any time by pressing and holding the
button. While the test is being interrupted, the "Internet test" LED will
indicate this by short, repeated flashing. Once this is complete, the Internet
connection test will return to standby, i.e. the LED will go off.
As soon as the Internet connection test is completed, the result will be
displayed in a PASS/FAIL format using the "Internet test" LED:
•
If the test was successful, the LED will light up continuously.
•
If the test failed, the LED will flash quickly. If you require further
error analysis, you can read out the reason for the failure using the
VIT-A2 Watch software.
In each of these cases, you will still need to exit the test by pressing and
holding the button. The "Internet test" LED will go off and the Internet
connection test will return to standby.
The following table provides a summary of the different possibilities that
can occur during the Internet connection test.
Condition
-
Test in standby
Test begins,
ADSL not
synchronized
Test begins,
ADSL
synchronized
Test running
Test result
ready
36
Action Status
- Standby
Long Test will begin
keypress
- Test in wait status
- Test running
Long Test is interrupted
keypress prematurely, returns
to standby
- Test completed with
error
LED indication
LED off
-
Slow interrupted flashing
Slow continuous flashing
Short repeated flashing
during interruption, then
LED goes off
Fast flashing
70299.207 – 1.3 – 20070802 – VIT-A2