Control Panel - Hunter Industrial XP Manual De Instrucciones

INS TA L LAT IO N
Electric Shock Hazard.
To prevent serious injury or death:
• BEFORE installing or servicing your fan, ALWAYS disconnect the power by turning
off the circuit breaker or breakers to the fan locations and confirm Lockout/
Tagout procedures are in place.
• If you cannot lock the circuit breakers in the off position, securely fasten a
prominent warning device, such as a tag, to the electrical panel.
• All wiring must be in accordance with national and local electrical codes,
including ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a
qualified electrician.
• The electrical receptacle for the panel should be installed prior to panel
installation. For a chart of receptacles, refer to page 19.
• Do not use an extension cord with fan.
• Do not remove covers while power is on.
• Do not use improper voltage source.
15
4

CONTROL PANEL

Electric Shock Hazard