Krampouz GGCIM1 Instrucciones De Uso página 19

Never use a leaky appliance.
CHANGING THE GAS CYLINDER
Always change the gas cylinder with the control levers and the gas cylinder valve closed.
Change the gas cylinder in a well-ventilated location away from any heat source (cigarettes,
electrical appliance, etc.).
Whenever you change the gas cylinder, perform a leak-tightness test.
Use
POWERING ON
 The appliance is ready for operation
 Open the gas cylinder valve
 Open the plancha valve by turning the lever to the high flame position (drawing on the
ring around the lever).
 Push the lever to this position against the frame for a few seconds, then activate the
electronic lighter to switch the burner on. Check that the burner is completely lit by
looking through the openings on the side of the appliance.
 Maintain pressure on the lever for between 5 and 10 seconds to engage the
thermocouple safety system (see figure 5).
 Then release the lever and allow the burner to heat the cooking plate to the appropriate
temperature.
 Preheat the plancha by setting it to the high flame position for 5 to 10 min, then reduce
to the low flame position.
 Your appliance is ready to be used.
COMMENTS
The first time it is used, it may be normal to see some smoke and smell some odours coming
from the appliance. This is normal.
EXTINCTION
 After use, switch off the appliance by setting the 2 levers vertically to the large full circle
position.
 Close the valve on the gas cylinder
 Disconnect the supply hose from the appliance and store it in a dry and well-ventilated
location. The gas cylinder must also be stored in a dry and ventilated location, away
from any source of heat.
COOKING
With its two separate heating zones, your double Design plancha allows simultaneous cooking
of two different types of food, for example: meat or fish on one side, vegetables on the other.
- 19 -