System Maintenance - 3M Easy Shine Guia De Inicio Rapido

Using the system (continued)
2. Dispense a line of finish in a U-shaped
path, keeping the applicator 4"- 6" away
from walls (Fig. 9). Feather the film
right up to the walls as you return over
the same path. Fill in the center area
using uniform figure eight or straight-
line strokes.
Fig. 9
System clean-up
1. Remove applicator pad from holder.
Rinse pad with water until all finish
residue is removed. Allow pad to dry
thoroughly before storage.
2. Rinse tool, delivery nozzle and hose end
with clean water.
3. Long-term storage—Using a refillable
bag filled with clean water, flush floor
finish out of the tubing assembly by
dispensing the water as outlined in
Step 1, Using the system. 3M
Shine Reusable Pouches are available
with the 3M Easy Shine Fill Station
™
(order #55441). The 3M Easy Shine
Reusable Pouches can be ordered
without the fill station (order #55440).
To order, call your 3M distributor or for
the name of the distributor nearest you,
call 1-800-852-9722.
Parts? Contact your local 3M distributor or call 3M Customer Service 1-800-852-9722.
3
Commercial Care Division
3M Center
St. Paul, MN 55144-1000
www.3M.com/commcare

System maintenance

For clogged dispense tubes
If applicator becomes clogged, invert
the handle, pull the lever and pull on the
dispense tube to break off any
hardened finish.
Replacing dispense tubes
To replace dispense tube, invert handle,
release the lever and pull the dispense tube
out of the handle. Pull the old dispense
tube off the elbow fitting and slide a new
dispense tube on. Reinsert the dispense
tube into the handle by pulling the lever
and threading the tube through the holes
until it extends all the way through and
the elbow fitting is tight against the handle
(Fig. 10 and 11).
(5) replacement dispense tubes
are provided.
To order 3M
Supply Tubing with Quick Connect
(order #55437) and/or 3M
Replacement Dispensing Tubes (order
#55438) call your 3M distributor or for
the name of the distributor nearest you,
call 1-800-852-9722.
Easy
™
Questions? Contact 3M Technical Support 1-800-626-8578.
Minimum 10% Post-Consumer Fiber
Recycle, Neg
Easy Shine Replacement
™
Easy Shine
™
Fig. 10
Pull dispense tube
through handle.
Dispense tube.
Pull the lever.
Fig. 11
�
Attach new dispense
tube to elbow fitting.
�
Feed dispense tube
through handle.
Pull the lever.
�
Release the lever.
3M is a trademark of 3M.
Printed in U.S.A.
© 3M 2005 34-8510-0298-9
Elbow
fitting.
Supply
tubing.