3M Easy Shine Guia De Inicio Rapido

3M Easy Shine Applicator System Instructions
TM
Setup/system assembly
1. Remove handle, pad holder, two
microfiber pads and bag of five
applicator tubes from carton.
2. Cut the wire tie holding the tube
fitting to the handle. Be careful not
to cut the tubing.
3. Extend the handle by depressing the
pushbutton locks simultaneously
and pulling the handle sections in
opposite directions until buttons lock
into place. Use the alignment arrows
on the handle to assist you (Fig. 1).
4. Attach the pad holder to the handle
by placing the pad holder on a flat
surface (Fig. 2).
5. Retract spring-loaded pin on end
of handle (Fig. 3). Position handle
base between either sets of holes on
the pad holder and release the tab to
secure handle to base.
6. Attach microfiber pad to the pad
holder by placing pad underneath
holder and pressing down (Fig. 4).
7. Unfold backpack and insert 1 gallon
bag of finish into pack so that spout
protrudes from opening (Fig. 5).
8. Remove the dust cap from the spout
and connect the end of the applicator
hose to the spout (Fig. 6). Place pack
on back and adjust straps
for comfort.
Using the system
1. Using the trigger at the top of the
handle (Fig. 7), dispense a 4" puddle
of finish in your starting area
(Fig. 8). Use a swirling motion to
wet the pad evenly for first-time use.
(Continued on opposite side.)
Fig. 1
Depress to
extend handle.
Fig. 3
Fig. 5
Pull spout
through opening.
Fig. 7
Trigger.
Fig. 2
Fig. 4
Holder.
Microfiber pad.
Fig. 6
Remove dust cap.
Fig. 8