Braun Syncro System Smart Logic 7680 Manual Del Usuario página 8

8
The SmartLogic inside your shaver will detect when the
shaver needs to be cleaned (refer to paragraph «Manual
cleaning» or to section B). To reset the display, push the
info key.
The SmartLogic inside will recognize when the shaver
has to be lubricated (refer to paragraph «Manual
cleaning» or to section B). To reset the display, push
the info key.
The shaver cannot be charged if the environmental
temperature is too low (<32 °F/0 °C) or too high
(>130 °F/55 °C).
Allow the shaver to remain for some time at room
temperature for optimal charging conditions.
No display: The rechargeable battery is completely
discharged and has to be recharged.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver:
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts
to every contour of your face.
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas,
e.g. under the nose).
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Shaving with the cord
If the rechargeable battery is discharged, you may also
shave with the shaver connected to the mains via the
power supply cord set.
(If the shaver does not run immediately, charge it with the
switch on position «0» for approx. 1 minute.)
Tips for the perfect shave
• It can take 14-21 days for your beard to adjust to the
new shaving system.
• We recommend that you shave before washing,
as the skin tends to be slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction
of beard growth.
• Replace the shaver foil and cutter block every
18 months, or when the parts are worn, to ensure
optimum shaving performance.