Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TENT SETUP
1. Release the straps over the travel cover.
2. Unzip the travel cover. You can remove it, roll it up, or let it
hang off the side of your vehicle.
3. Unbuckle the straps on the sides of the tent and across the
ladder.
4. Undo the red strap around the ladder and fully extend it until
the locking pins in each section engage.
5. Use the ladder as leverage to open the tent by pulling
straight back until the ladder rests firmly on the ground.
Assure all the steps on the telescoping ladder are locked.
The tent base should be level and the ladder should form a
60° angle with the ground.
6. To adjust the ladder height, start with the top section,
pressing the two buttons under the ladder rung to release
the locking levers. Slide the ladder up so that it recedes into
the top rung. Repeat for each section until the ladder is the
desired height. Be sure that the remaining sections of the
ladder are fully locked.
7. Unfasten the grommets on the awning and rainfly. Locate
the fabric slits in the tent skirt. Pre-drilled holes are located
underneath each slit. Insert the rainfly rod at a 45° angle into
the hole and bend slightly to hook the other end through the
grommet. Repeat this process for both holes in the awnings
and both holes at either end of the rainfly.
That's it! You're ready to camp.
To close the tent, remove the rainfly rods. Extend the ladder, using
it as leverage to close the tent. To collapse the ladder, press the
red buttons at the base of the ladder. Fasten the straps at the
sides of the tent and across the ladder before zipping on the
cover. Secure with the velcro straps that run across the cover.
7
Tabla de contenido
