Leer 1LG0300000 Manual Para Usuarios página 5

TENT ASSEMBLY
1. Four pre-drilled holes are located in
the center area of the tent base for
attaching the mounting tracks. Align
the holes in the mounting tracks over
the holes in the base.
CROSS BARS
REAR MOUNT
Mount perpendicular to hinge.
SIDE MOUNT
Mount parallel to hinge.
2. Slide the 10mm Nylock nuts
into the inner slot in the center
of the mounting tracks until they
are aligned with the holes in the
mounting tracks and the base.
3. Using the supplied 10mm bolts,
add two steel washers to each
bolt. Slide your hand between
base and mattress and insert bolts
with washers into the pre-drilled
holes. You may need to poke holes
through the tape to insert bolts. The
bolts should pass through the holes
in the tent base and the mounting
tracks, into the nuts in the inner slot
of the mounting track. Reach under
the mattress and tighten the bolts
firmly using the supplied 10mm
wrench.
4. Flip the tent over. Attach the ladder
brackets to the pre-drilled holes at
the edge of the tent base using the
bolts on the ladder brackets. Slide
the bolts between the mattress and
the base, passing each one through
a steel washer, the hole in the
tent base, and the ladder bracket,
followed with a nylock nut.
5. Attach the brackets to the ladder by
threading the shorter bolt through a
steel washer, the lateral side of the
ladder bracket, the rubber washer,
and the hole in the ladder, followed
by a nylock nut.
6. After attaching the ladder, rotate it
several times on the brackets and
tighten all bolts.
5