Lenco L-92 Manual De Usuario página 8

CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL.
WARNING:
-
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH
LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.
-
THE MAINS PLUGS OR AN APPLIANCE COUPLER IS USED AS THE DISCONNECT DEVICE, AND THE DISCONNECT
DEVICE SHALL REMAIN READILY OPERABLE.
PRECAUTIONS FOR USE
INSTALLATION
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
⚫
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE ALL OTHER
⚫
CONNECTIONS HAVE BEEN MADE.
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS AROUND THE
⚫
UNIT FOR VENTILATION.
CONNECTION
CONNECT THE EXTERNAL POWER ADAPTOR WITH EXTERNAL POWER ADAPTOR SOCKET.
1.
PLUG THE EXTERNAL POWER ADAPTOR INTO A SUITABLE MAINS SOCKET
2.
PUSH IN THE ON/STANDBY BUTTON ON THE BACK PANELTO SWTICH ON THE UNIT FROM STANDBY MODE.
3.
OPERATION
-
INSTALL THE DUST COVER INTO HINGE ON THE UPPER CABINET.
-
SET THE TURNTABLE PLATTER ONTO THE CENTER SPINDLE.
-
ATTACH THE DRIVE BELT: POSITION THE BELT ON THE MOTOR PULLY, THE DRIVE BELT IS TIGHTENED UNDER THE
TURNTABLE PLATTER.
-
PLACE THE SLIP MAT ON THE TURNTABLE PLATTER.
-
INSERT THE HEADSHLL INTO THE FRONT END OF THE TONEARM, THEN SCREW THE LOCK NUT WITH THE
HEADSHELL FIRMLY HELD HORIZONTALLY.
8