Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.
Ventilation holes for motor
8.
Carbon brush cover
9.
Lid for greasing inlet
* Differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1.
Chisel
2.
Additional handle
3.
Dust cover
4.
Grease container
5.
Special key
6.
Transport case
INSTALLATION OF ADDITIONAL HANDLE
Due to safety issues, always use additional handle (4) when operating the demolition hammer. It can
be fixed in any position from the range of 360
Disconnect the power tool from power supply.
●
Slide the additional handle (
●
Fix the screw that joins two parts of the handle with holders.
●
Recess in the screw head should match protrusion on the handle flat bar (protection against turning).
●
Join the clamping wheel of the handle (
●
Turn the handle for the position that is most comfortable for the work performed.
●
Tighten the clamping knob to finally clamp the handle (
DUST COVER INSTALLATION
Anti-dust cover is a rubber casting of appropriate shape. Place it on the tool holder to catch dust when
operating the demolition hammer. Fix it to the tool holder before starting operation.
INSTALLATION AND REPLACEMENT OF WORKING TOOLS
Demolition hammer is designed to operate with working tools with 30 mm hexagonal shanks. Prior to
starting operation clean the demolition hammer and working tools. Apply thin layer of grease onto shank
of the working tool.
Disconnect the power tool from power supply.
●
Pull the tool holder bolt (
working tool into the tool holder (1) (fig. A).
●
Insert working tool shank into tool holder (
may be necessary to turn the working tool so it can reach appropriate position).
●
Pull the tool holder bolt (
sure the bolt is in correct position – secured).
●
Working tool is properly seated if it cannot be removed from the tool holder without pulling off and turning
the tool holder bolt.
●
If the working tool is not appropriately secured, remove it from the holder and repeat the whole
operation.
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 1 pce
PREPARATION FOR OPERATION
O
.
4) collar over cylindrical part of the demolition hammer body.
3) and the screw.
2) against the spring and turn it by 180
1) through anti-dust cover, and slide it to mechanical stop (it
2) again and turn it by 180
11
4).
0
to position it properly, so you can insert
0
to lock the working tool in the tool holder (make
Tabla de contenido
