Noise And Vibration; Instructions For Use; Inserting/Replacing The Battery - Flex CHE 2-26 18.0-EC Instrucciones De Funcionamiento Originales

CHE 2-26 18.0-EC

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A-weighted noise level of the power tool
is typically:
– Sound pressure level:
– Sound power level:
– Uncertainty K:
Total vibration value:
– when hammer drilling:
– Emission value a
– Uncertainty K:
– when chiselling:
– Emission value a
– Uncertainty K:
ATTENTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE!
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary to
take into account the times when the tool is
switched off or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
90 dB(A);
101 dB(A);
3 dB.
: 15.9 m/s
h
1.5 m/s
: 12.7 m/s
h
1.5 m/s

Instructions for use

Before switching on the power tool
Unpack the power tool and accessories and
check that no parts are missing or damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Inserting/replacing the battery

2
2
 Press the charged battery into the power
tool until it clicks into place.
2
2
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
17