Rola 59713 Manual De Instrucciones

PART No: 59713, 59714,
Fitting Instructions
59715, 59834
APE (Anchor Point Extended)
50Kgs/
CARRYING CAPACITY:
Cross Bar Kits
110 Lbs
Note: Prior to Assembly Parts list
Prior to assembling your cross bar kit check
that the kit contains all the parts you will need
to fit the cross bars. Refer to parts lists for
guidance.
Please read these instructions before assembly.
Cross Bars
Under Cover
Step 1: Removing the vehicles anchor point covers.
On the vehicles roof or ditch molding you will find fore
and aft anchor point covers (fig 1).
Carefully remove these covers by sliding them in the
direction shown on the cover. This will reveal the anchor
points. It is advisable to screw the bolts into the anchor
Plastic adaptor
point threads at this time to clean the threads.
End support
Note: Take care when removing the covers to avoid
Rubber Gasket
damaging or losing clips. Covers will not be replaced
while the cross bars are on the vehicle.
Store the covers and any plugs while cross bars are in
M8 spring washer
use for later replacement.
M8 hex nut
M6 x 45mm bolt
L wrench
M8 washer
Clamp plate
Cross bar end End cap key
M8 x 20mm Bolt
caps
Anchor point
Vehicle's roof Anchor point
cover
Fig. 1
Tool required – 13mm or adjustable wrench
Rubber Gasket
Plastic adaptor
Step 2: Installing Rubber Gaskets and Adaptor
Position the rubber gaskets over the anchor points as
shown in fig 2.
Ensure that the gasket is properly aligned.
If your gasket has a directional arrow this always
Anchor point
points toward the front of vehicle.
Ensure that the gasket slots are centered over the
anchor point threads in the roof.
Vehicle's roof Vehicle's roof
Place the plastic adaptors into the gasket's recessed
Fig. 2
top surface (fig 3).
Front of
vehicle
Fig. 3
Location of anchor points on vehicle
122274N REV 3-9-12
Printed in China
Pg 1 of 2