How To Use; Getting Started; Resetting Your Vornado Heater - Vornado TVH500 Guia Del Propietario

Getting Started

Using your Vornado Heater is easy. Just follow these simple steps.
1. Position your heater so the vortex beam of warm air is directed
across the room unobstructed. Position it in a location that
is representative of the room temperature. Avoid areas of
temperature extremes such as cold drafts and heat registers (refer
to IMPORTANT INSTRUCTIONS for safe placement).
2. Plug into a standard grounded wall outlet.
3. Press the Power button.
4. Select the mode you wish to use (Low, High or Fan Only.)
5. Set thermostat to desired temperature using the up and
down arrows.

Resetting Your Vornado Heater

Your Vornado Heater has a multi-level safety shut-off system
designed to prevent overheating. Overheating may occur when
the inlets or outlet are blocked, a foreign object prevents the
blade from turning, or the appliance tips over. If this happens,
the safety shut-off system will cut power to the heat element
and you will need to manually reset the heater.
1. Turn the Power switch Off and unplug the unit.
2. Remove any obstructions.
3. Wait 5 –10 minutes, allowing the unit to cool down.
4. Plug in the unit and place in desired position.
5. Turn the Power switch On. Your Vornado Heater should now
function normally.
Note: If the safety shut-off system repeatedly shuts off
your heater or if it will not reset after following the above
procedure, DO NOT ATTEMPT TO DISASSEMBLE THE
UNIT. Call Vornado Consumer Services Department toll-free
at 1-800-234-0604.

How To Use

English
7