Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONTENTS
1
Introduction to instructions and warnings
This manual is intended only for qualified technical
staff authorized to install the machine.
The informations in this manual are not intended
for the final user.
This manual refers to AG/CTRL control units for
automation made of a ROGER AGILIK barrier; it
should not be used for other devices.
Danger of
WARNINGS
Electric shock
Carefully read this section before installing the
machine.
Page
In order to avoid risk of electrocution and physical
injuries, before performing any operation on the
device, please cut off the power supply.
23
The machine must be installed only by qualified
24
staff, following the laws in force.
24
Perform the connections using appropriate cables
for the required current and voltage, respecting
the technical features of the product. Check the
compliance of the grounding system and the
continuity between the grounding of the motor and
25
the terminal of the control unit.
25
2
26
Product description
26
AG/CTRL control unit enables automation control
by means of two high resolution magnetic encoders:
encoder 1 mounted on the rear side of the brushless
27
motor and controls the motor, while encoder 2 is
28
mounted on the side of the gear reducer controls
28
the position of the barrier, even when is set to
28
manual mode; digital signal generation ensures
29
high performance, reliability and intensive use. The
29
cover cap is suitable for the installation of a double
30
LED signalling system, consisting of a MASTER board
30
and a SLAVE board; it can be configured as either
30
flashing or - alternatively - as semaphore signalling
(in this case the flashing system should be installed
31
externally).
39
39
It is also possible to install the lights on the barrier,
39
the photocells, a safety edge, keyboards, key
116
selectors, an external flash, a radio receiver, a led
that indicates the open/closed status, an electric
locking system and a clock.
There are two configuration levels: a simple one
that satisfies
and an extended one (advanced level) where the
automation can be customised.
the majority of the installations
EN
23
Capítulos
Tabla de contenido
