Product-Specific Safety Instructions; Additional Safety Instructions - Hilti PMD 200 Manual Del Usuario

▶ Disconnect the plug from the power source and/or remove the battery before making any
adjustments, changing accessories, or storing the appliance. This precaution reduces the risk of the
power tool starting accidentally.
▶ Remove the battery before storing or transporting the product. Store the product in a dry place where it
cannot be accessed by children or unauthorized persons.
2.2

Product-specific safety instructions

Using and handling the measuring tool
▶ Rapidly changing measuring conditions can falsify the result of measurement.
▶ Keep the product clean and dry at all times.
▶ Always check the device settings before using it.
▶ Use the product only within its specified limits.
2.3

Additional safety instructions

Work area safety
▶ Keep the work area clean and uncluttered and watch out for supply cords routed in the work area.
Carelessly routed supply cords can constitute trip hazards and lead to injuries. Measuring tools mounted
on tripods can topple and be damaged if a supply cord is accidentally pulled. Make sure you are aware of
everything that is happening around you when you change position while using the remote control unit.
Personal safety
▶ The product complies with Laser Class 2 in accordance with IEC/EN 60825-1:2014 in accordance with
CFR 21 Sec. 1040 (FDA). This product may be used without need for further protective measures.
Nevertheless, as with the sun, do not look directly into the light source. If you do inadvertently look into
the laser beam, immediately close your eyes and move your head clear of the laser beam. Do not aim
the laser beam at persons.
▶ If the product falls from an elevated position there is a risk of injury to persons. Use only tripods
recommended by Hilti.
▶ Wear your personal protective equipment and always wear protective glasses. Depending on the type
of product you are using and its purpose, wearing personal protective equipment such as a dust mask,
non-slip safety shoes, hard hat, or hearing protection reduces the risk of injury.
Using and handling the measuring tool
▶ Maintain the measuring tool carefully. Check that moving parts are in full working order and do not jam
and make sure there are no parts that are broken or damaged in such a way as to impair operation of
the measuring tool. Have damaged parts repaired before using the tool. Poor maintenance of measuring
tools is the cause of many accidents.
▶ Make sure that the scanning tool is standing firmly on all three of its rests or is correctly secured to the
tripod recommended by Hilti.
▶ To avoid inaccuracies, always make sure that the target plate is always perfectly plumb when
points are marked. Use the adjusting screw and the bubble level for adjusting and checking.
▶ Never use a damaged target plate. Risk of inaccurate measurement.
▶ Check the accuracy of the product before use and several times during use.
▶ Although the measuring tool complies with the strict requirements of the applicable directives, Hilti
cannot entirely rule out the possibility of interference caused by powerful electromagnetic radiation,
possibly leading to incorrect operation.
2.4 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
14 English 2275630
*2275630*