Idiomas disponibles
Idiomas disponibles
Retrofit And New Construction Application (Covered
Canopy)
N
ote:
Incoming power leads must not exceed 16 gauge.
1.
Make sure power is turned off.
2.
If retrofitting, remove old fixture from the canopy
ceiling. If new construction skip to Step 4.
3.
Clean the entire surface on both sides of the canopy
surface around the opening. Remove any dirt, debris,
old paint, sealant and rust scale. Clean approximately
2 feet in each direction on top of the canopy;
approximately 6 inches on bottom of canopy.
4.
Using the existing opening as center point, cut out 14
x 14 inch square opening in the canopy with template
provided (Figure 1a).
5.
Use the template to screw in four sheet metal screws
provided from bottom side of canopy (Figure 1b).
6.
Remove new fixture from carton and set it on a clean
surface; remove the driver box door by loosening four
Philip head screws. Set the door and screws aside.
7 .
With the incoming wires coming through 1/2" water
tight conduit, insert incoming power leads into the wire
holes in grommet provided; Make sure to have at least
3" of wires through the grommet; Push the grommet
into the conduit opening.
8.
Secure water tight conduit with connector and
incoming power leads into the hole of the driver box
housing. The conduit connector must have a gasket
on outside for sealing. Tighten the connector with
locknut on the inside of the driver box. Make sure the
connector is snug fit against the box opening.
9.
Make splice connections inside the box: Connect Black,
White and Ground wire inside the box with matching
wires by lifting the wago connector levers and inserting
wires into the connectors. Once inserted properly,
press lever back into lock position and tug on the wires
to make sure proper connection is made.
10. Tighten the driver box door back with philip head
screws (25 in. lbs. torque) and ensuring driver box
gasket stays in place during this step.
N
ote:
For vertical wide reflector only (LRC-VAT), before
Step 11 properly orient the fixture (figure. 2) As
desired; locate the orientation label and orient the
fixture accordingly. Arrow should point to direction of
throw.
11. Flip fixture over and loosen four door screws. Carefully
place the door aside while making sure not to scratch
the glass lens and painted door.
N
ote:
Do not remove the corrugated sheet from the
opening until after installation.
12. Insert fixture through the canopy opening diagonally
(Figure 3) and rest it on top side of the canopy. Make
sure the splice conduit does not get caught under the
fixture during installation.
Installation instructions – LED Recessed Canopy
Figure 4.
1/4"
[6mm]
1"
[25mm]
Figure 5.
Use Two Studs
(Diagonal Across)
And Matching Hole in
Housing as Alignment
Guide for Door Screws
Figure 6.
COOPER LIGHTING SOLUTIONS
Bead Trace
Attach Tether to One
Stud With Nut Provided
IB515007EN
Installation instructions
1"
[25mm]
3
