ACM TRONIX Serie Instrucciones Y Advertencias Para El Instalador página 25

DELETION OF ALL MEMORIZED TRANSMITTERS
To delete all codes stored with an TX-PLUS / TX-FIT1 proceed as follows:
1. Supply power only to the control unit to be programmed
2. Activate the TX-PLUS / TX-FIT1 programming
3. Press the UP or DOWN keys until the led performs n. 3 flashes (select the L1+L2 for TX-FIT1)
4. Press and hold down the UP+DOWN keys until the motor moves in both directions which confirms the correct de-
letion of the codes.
5. Release the keys
6. To exit the programming mode press the STOP key
To delete all codes NOT stored with an TX-PLUS / TX-FIT1 proceed as follows:
1. Cut the power to the motor on which to delete all the codes
2. Activate the TX-PLUS / TX-FIT1 programming
3. Press the UP or DOWN keys until the led performs n. 3 flashes (select L3 for TX-FIT1)
4. Press and hold down the UP+DOWN keys
5. Power the motor and wait until the motor moves in both directions wich confirms the correct deletions of the codes
6. To exit the programming mode press the STOP key
PROGRAMMING THE WIND SENSOR INTERVENTION THRESHOLD
CAUTION: to trigger the closing of the sunshade, the wind sensor must detect a value greater than the set threshold
for at least 5 seconds. The closure of the sunshade caused by strong wind stops the automated system for 8 minutes.
To set the wind sensor intervention threshold, it is necessary to use a remote control previously stored and proceed
as follows:
1. Supply power only to the control unit to be programmed
2. Activate the TX-PLUS / TX-FIT1 programming
3. Press the UP or DOWN keys until the led performs n. 7 flashes (select L1+L2 for TX-FIT1)
4. Press the UP+DOWN keys until the motor moves in jerks which confirms it is entering the programming phase. The
number of jerks made by the motor corresponds to the level currently set:
1 jerk = level 1 = 10 Km/h
2 jerks = level 2 = 15 Km/h
3 jerks = level 3 = 20 Km/h
4 jerks = level 4 = 30 km/h (default value)
5 jerks = level 5 = 40 Km/h
5. Release the keys
6. To increase the level press the UP key and to decrease it press the DOWN key, as soon as the control unit receives the
command, it shows the new level by operating the motor with a corresponding number of jerks
7. When the desired value is reached, press the STOP button: the control unit will show the set value again to confirm
8. To exit the programming mode press the STOP key
English – E