ACM TRONIX Serie Instrucciones Y Advertencias Para El Instalador página 23

FIG.7
TX-PLUS 1
QUICK TRANSMITTER DATA STORAGE
CAUTION: The data storage of the first transmitter determines the direction of motion of the motor.
CAUTION: If the awning has a casing carry out the data storage of the first remote control by following the pro-
cedure "TRANSMITTER DATA STORAGE"
To store your remote controls on a virgin control unit which
drives a shutter or an awning (WITHOUT casing) proceed as follows:
1. Supply power only to the control unit to be programmed
2. Activate the programming by following one of these procedures
TX-PLUS1 / TX-FIT1:
• Press and hold down the UP+DOWN keys until the motor starts to move in one direction
TX-PLUS2:
• Press the UP+DOWN keys of one of the two channels until the motor starts to move in one direction
TX-PLUS4:
• Press and release the key of the channel to be programmed, the LED will light up
• Press the UP+DOWN keys until the motor starts to move in one direction
3. Release the keys: the motor stops
4. Press the UP or DOWN keys according to the direction in which the roll-up shutter was moving before it stopped:
- if the roll-up shutter was being raised press the UP key; direction obtained: the UP key raises the roll-up shutter, the
DOWN key lowers the roll-up shutter
- if the roll-up shutter was being lowered press the DOWN key; direction obtained: the DOWN key lowers the roll-up
shutter, the UP key raises the roll-up shutter.
5. Programming is complete
To add additional remote controls, proceed as follows:
6. Press and hold down the UP+DOWN keys of a remote control which has already been programmed until the motor
starts to move in one direction
7. Release the keys: the motor stops
8. Press the UP or DOWN key of the new remote control
ADVANCED PROGRAMMING
To perform ADVANCED programming it is necessary to activate the programming by following one of the following
procedures:
ACTIVATION OF PROGRAMMING TX-PLUS1 / TX-FIT1:
• Press the STOP + UP + DOWN keys
• When the LED lights up, release all the keys
• Programming is activated for 30 seconds
TX-PLUS 2 TX-PLUS 4
1
2
3
4
TRANSMITTER DATA STORAGE
UP
STOP
DOWN
ALL
TX-FIT 1
L1 L6
UP
STOP
DOWN
English – E