ACM TRONIX Serie Instrucciones Y Advertencias Para El Instalador página 22

FIG.6 Ø 35 Ø 45
SX: Left Installation DX: Right Installation
DESCRIPTION
This opening system is made of a tubular motor with built-in control unit with the following characteristics:
• It is provided with a 434.15 MHz super-heterodyne radio receiver.
• Up to 48 different channel can be stored on each central unit.
• It is driven by means of transmitters TX-PLUS and TX FIT.
• It is possible to drive the awning / rolling shutter also by mean of an external push-button (type: Normally Open, each
series or model).
• The programming phase can be effected via radio or by means of an external switch.
• It is necessary to use a sesor model WINDY.
FUNCTIONING WITH EXTERNAL WIRED SWITCH
Pressing the external wired switch, the control unit has the following functioning logic:
OPENS - STOPS – CLOSES...
FUNCTIONING WITH TRANSMITTERS
At each push button pressure, the functioning logic is the following.
UP: CLOSES
STOP: STOPS
DOWN: OPENS
SENSOR ACTIVATION
To activate the sensors function, at least one transmitter must be stored.
• Anemometer causes inhibition of functioning of both radio transmitter and external push button for ca. 8 minutes.
• The anemometrical sensor should be installed close to the awnings, in order to avoid damages in case of very strong
wind.
WORKING TIME OF MOTOR
The control unit stops the motor movement after 2 minutes: in case of limit switches malfunction this "time out" avoids
the motor overheating.
E – English