Gearcase; Qc-Es (Edger Attachment); Qc-T (Cultivator Attachment) - Maruyama QC-E Manual Del Propietario U Operador

Flexible Driveshaft
DriveShaft Tube
4. Reinstall the flexible driveshaft into the driveshaft
tube. Twist the flexible driveshaft as you insert it
into the to ensure that it seats into the clutch drum.
5. Reinstall the gearcase onto the driveshaft tube,
then tighten the two screws.

Gearcase

Maintenance Interval
The gearcase lubricant should be inspected after every
30 hours of use.
Gearcase Maintenance
Remove the cutting attachment and the boss adapter.
Clean any dirt and debris from the area between the
boss adapter and the gearcase. Remove the grease plug
from the side of the gearcase. While rotating the attach-
ing shaft, inject lithium-base bearing lube (P/N 211337)
through the plug hole until the gearcase is full. Re-
install the grease plug.
Bearing Lube
(P/N 211337)
Gearcase
Attaching Shaft
Gearcase
Screw (2)
#2 Lithium-base
Bearing Lube
Grease Plug
Plug Hole
Boss Adapter

QC-ES (Edger Attachment)

Gearcase
Maintenance Interval
The gearcase should be inspect after each 30 hours of
use.
Gearcase Lubrication
The gearcase should be checked for lubrication after
each 30 hours of use. Grease fittings are installed. Use
#2 lithiumbase bearing lubricant.
Attaching Shaft
Boss Adapter

QC-T (Cultivator Attachment)

Gearcase
Maintenance Interval
The cultivator gearcase should be inspected after each
25 hours of use.
Lubrication
The cultivator gearcase holds 1.4 ounces of lubricant. A
grease fitting is located in the top of the gearcase.
Lubricant should be checked at least every 25 hours of
operation. Use a #2 lithium-based EP lubricant with
Molybdenum additive.
Gearcase Fitting
— US-17 —
Grease Fitling
Gearcase