Operation; Qc-E/Qc-Es (Multi-Cutter With Edger Attachment); Operating Position - Maruyama QC-E Manual Del Propietario U Operador

and backward and left turn and right turn. When
the shaft assembly is positioned correctly, spring
tensioned positioning lever will be returned to the
initial position.
3
Tighten the clamping knob firmly.
Detaching
1 First, loosen the clamping Knob before detaching
the shaft assembly to the shaft coupler.
2 Pull out the shaft assembly from the shaft coupler
while holding the positioning lever down.
3 Note : Do not over loosen the clamping knob or it
may fall out.
Positioning Lever
Clamping Knob
Loosen
Push down
Shaft Assembly
Removal
— US-13 —

Operation

QC-E/QC-ES (Multi-Cutter with
Edger Attachment)
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by
Edger.
WHAT CAN HAPPEN
• Contact with thrown objects can
cause personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Edger without the
blade shield in place.
• Make sure the blade shield is correctly
positioned to shield operator from
thrown debris.
CAUTION
• Read the Safety instructions on US-6
concerning proper use of the Edger.

Operating Position

Before using the Edger, check the following:
1. Make sure the 3 mm hex wrench has been
removed from the gearcase and boss adapter
before you start the engine.
Gearcase
3 mm Hex Wrench
Edger Blade
Attaching Shaft
Boss Adapter
Blade Bolt (left
hand thread)
Clamping Washer
[QC-E]