Operation; Maintenance; Wiring Diagram - Luna BBS500 Traducción De Instrucciones Originales En Inglés

5.0 Operation

The blade cuts on a continuous downstroke.
With both hands, fi rmly hold the workpiece down on the table, and feed it
towards the blade slowly, keeping your hands away from the blade. For best
results the blade must be sharp. A dull blade will not cut correctly, espe-
cially when straight cutting, and causes excess pressure to be applied on the
rear guide bearings.
Select the right blade for the job, depending on the thickness of the wood
and the cut to be made. The thinner and harder the wood, the fi ner the teeth
of the blade. Use a fi ne tooth blade for cutting sharp curves. The machine is
especially suited for cutting curves, but will also make straight cuts. When
cutting, follow the design marked out by pushing and turning the workpiece
evenly. Do not attempt to turn the workpiece without pushing it, as this may
cause the workpiece to get stuck, or the blade to bend. For straight cuts, use
the fence provided to feed the workpiece along the blade slowly and in a
straight line.

6.0 Maintenance

CAUTION! BEFORE CLEANING OR CARRYING OUT
MAINTENANCE WORK, DISCONNECT THE MACHINE FROM THE
POWER SOURCE (WALL SOCKET). NEVER USE WATER OR OTHER
LIQUIDS TO CLEAN THE MACHINE. USE A BRUSH. REGULAR
MAINTENANCE OF THE MACHINE WILL PREVENT UNNECESSARY
PROBLEMS.
Keep the table clean to ensure accurate cutting. Keep the outside of the
machine clean to ensure accurate operation of all moving parts and prevent
excessive wear. Keep the ventilation slots of the motor clean to prevent it
from overheating. Keep the inside (near the saw blade, etc.) clean to prevent
accumulation of dust.

7.0 Wiring diagram

WARNING! This machine must be grounded.
Replacement of the power supply cable should only be done by a qualifi ed
electrician.
38