Worx Sonicrafter WX673 Manual Del Usuario página 10

SYMBOLS
To reduce the risk of injury, user
must read instruction manual.
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
Do not dispose of batteries, return
exhausted batteries to your local
collection or recycling point.
10
High frequency multi-function tool
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing
and separating wooden materials, plastic,
plaster, non-ferrous metals and fasteners
(e.g. nails and clamps) as well as for working
on soft wall tiles and for dry grinding of
small surfaces. It is especially suitable for
working close to edges and for flush cutting.
BEFORE PUTTING INTO OPERATION
A) cHARGING THE BATTERy
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE OR INSTALL BATTERy
PAcK (See Fig. A)
Depress the battery pack release button to
release and slide the battery pack out from
your tool. After recharge, slide it back into
your tool. A simple push and slight pressure
will be sufficient.
OPERATION
wARNING: Do not touch the gear
box after long working time, because it
could be hot.
1. MOUNTING THE TOOL (See Fig. B1,
B2)
cAUTION: For all work or when
changing application tools, always
wear protective gloves. Avoid danger
EN