Tabla de contenido
3
Put the grille back into the vacuum cleaner by first hooking the bottom edge of the grille into
the appliance (1) and then pushing the grille towards the appliance (2) until it snaps home
(fig. 29).
Super Clean Air HEPA Filter (specific types only)
Instead of the Super Clean Air Filter, some types are equipped with the special Super Clean Air
HEPA Filter.This filter not only removes household dust, but also harmful microscopic vermin.
Replace the Super Clean Air HEPA Filter every 6 months.
1
Open the filter grille and remove the Super Clean Air HEPA Filter.
2
Place the new filter behind the brackets. Make sure that the Philips logo on the filter is visible
in the bottom right-hand corner (fig. 30).
3
Close the filter grille.
Ordering filters
Two Super Clean Air Filters and one Motor Protection Filter are available under type number
FC8032.
Super Clean Air HEPA Filters are available under type number FC8044.
Troubleshooting
Insufficient suction power
1
Check if the dustbag needs to be replaced.
2
Check if the filters need to be replaced.
3
Check if the electronic suction power knob is in maximum position.
4
Check if the nozzle, tube or hose is blocked up.
5
To remove the obstruction, disconnect the blocked-up item and connect it (as far as
possible) in reverse position (fig. 31).
6
Switch the vacuum cleaner on to force the air through the blocked-up item in opposite
direction. Make the airflow suck the obstructing material out of the blocked-up item.
Guarantee & service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal
Care BV.
ENGLISH
9
Tabla de contenido
