Hoover Sensory Instrucciones De Uso página 8

05655077_NEW 8/10/02
• Infrared remote control (K) (depending on model). Use + and - buttons on
the hand set to increase or decrease suction. Selecting Active Power Sensor
the cleaner will keep a constant performance during the majority of the
cleaning operation. A slight drop of performance will occur when the bag is
near full, indicated by the flashing light. IMPORTANT: Manually select low
power for delicate fabrics. Press Pause for short stops. When finished,
switch off by pressing the on/off button.
• Carpet and floor nozzle (L). Press pedal on the nozzle to lower the brush
head when cleaning hard floors. Press the pedal again to lift the brush
head when cleaning carpets.
• Turbo nozzle (depending on model). Use the Turbo nozzle for deep cleaning
on carpets. IMPORTANT: do not use Turbo nozzle on rugs with long fringes,
Animal hide and over carpet piles with a depth exceeding 15 mm. Do not keep
the nozzle stationary while the brush is rotating.
• Caresse nozzle (depending on model). Use over wooden floors to avoid
scratching.
• Multi function tool. Tool is stored on the handle (E1). Remove tool and use
as:
a) Crevice tool: for corners and hard to reach areas (M1).
b) Furniture nozzle: for soft furnishings and fabrics (M2).
c) Dusting brush (depending on model): for bookshelves, frames, keyboards etc.
(M2).
• Tube Parking and Storage (N). The tubes can be parked at the rear of the
cleaner or stored into the storage slot underneath of the cleaner.
REPLACING THE BAG/EMPTYING THE PERMANENT BAG
REPLACING THE BAG (depending on model):
When full (See "Electronic Bag Check Indicator" paragraph) please dispose of
the bag immediately.
• Open the top-cover and grip the bag holder. Lift the bag holder vertically
out of the cleaner (O1).
• Close the bag to avoid dust escaping by pulling the tongue. Dispose of the
full bag into the bin (O2).
• Fold and fit new bag into the bag holder (O3). Replace the bag holder into
the cleaner.
• USE ONLY HOOVER GENUINE BAGS
EMPTYING THE PERMANENT BAG (depending on model):
When full (See "Electronic Bag Check Indicator" paragraph) please empty the
bag immediately.
• Open the top-cover and grip the bag holder. Lift the bag holder vertically
out of the cleaner (P1).
• Remove the Permanent bag from the bag holder.
• Remove the plastic guide at the end of the bag allowing dirt collected to
fall into the bin (P2).
• Return the guide back into the original position.
• Fit the empty Permanent bag into the bag holder (P3). Replace the bag
holder into the cleaner (P4).
• Check filters for excessive build up of dust. If required, clean or replace.
Close the top-cover. See diagram (B1, 2, 3) to access the filters.
• To maintain best performance we recommend you wash the filters and the
Permanent bag (depending on model) after 5 full bags. Please refer to
chapter "Filters maintenance".
FILTERS MAINTENANCE
• To maintain best performance we recommend that you wash the filters after 5
full bags.
• To access the filters please refer to diagrams B1, 2, 3
• Rinse both filters under hand warm water (Q1 and Q2).
• Do not scrub the filters.
• Remove excess water with a dry cloth and leave to air dry for 24 hours or
until fully dry (Q3).
• After completing the washing operations, return the filters to their original
positions in the cleaner.
11:46 AM Page 8
GB