dBTechnologies VIO S118 Manual Del Usuario página 44

LED TYPE SPEAKER
TURN-ON PHASE
LIMITER OFF
OFF
SIGNAL
MUTE/ ON FOR A FEW
PROT SECONDS
READY OFF
10. RDNet NETWORK CONNECTION INPUT ("Data In")
For network cables with etherCON/RJ45 connectors.
Connect it to devices like RDNet Control 2 or Control 8 to use the remote control.
11. RDNet NETWORK CONNECTION DAISY CHAIN ("Data Out")
Compatible with network cables with etherCON/RJ45 connectors.
It is used for the remote control network daisy chain to further system modules in daisy-chain configuration.
12. CONTROL LEDs
LEDs relating to module network operation (RDNet).
In particular, if "Link" is on the RDNet network is active and has acknowledged the device, if "Active" is flashing
there is data traffic, if "Remote Preset Active" is on all local control on the amplifier panel are by-passed by the
RDNet remote control.
13. SYSTEM TEST
It carries out a test with sweep signal to check woofer integrity. This test must not be considered as thorough, but
just a first check in the analysis of any issues.
14. SERVICE DATA USB PORT
It is a USB B port to be used only for product firmware update. For further information refer to "FIRMWARE
UPDATE".
VIO-S118
44
IN NORMAL
FUNCTION
OFF, IT TURNS
ON ONLY
IN CASE OF
TRIGGERING
ON
IN THE PRESENCE
OF A SIGNAL
OFF
STEADY ON
Table of the status LED signals
GENERAL BLOCK FOR
WARNING SPEAKER
MALFUNCTION
TEMPORARY CONTINUOUS CYCLIC
FLASHING FLASHING
NORMAL OFF
SIGNAL OF
INPUT
AUDIO
TEMPORARY STEADY ON
FLASHING
STEADY ON OFF
English
Cod. 420120259 REV. 1.0