Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Proper Hand Position (Fig. C–E)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
WARNING: Hold the tool using only the designated
gripping surfaces: The powerhead handle and the
auxiliary handle.
WARNING: Do not use the pole as a gripping surface.
Proper hand position requires one hand on the powerhead
handle
15
and one hand on the auxiliary handle
WARNING: Do not operate blower without blow
tube securely in place. Never reach down into housing
through tube hole.
WARNING: Always wear safety glasses. Always wear
respiratory protection. Always wear hearing protection.
Use of rubber gloves and substantial footwear is
recommended when working outdoors. Keep long hair
and loose clothing away from openings and moving
parts. For household use only.
WARNING: Cut Hazard. When turning the tool
off, wait 10 seconds for the fan to stop rotating
before removing the blower tube.
•
Always ensure the blower is switched OFF and the
battery is removed when:
‑
You leave blower unattended.
‑
Clearing a blockage.
‑
Checking, adjusting, cleaning or working on blower.
•
Only use blower in daylight or good artificial light.
Switching On and Off (Fig. C)
WARNING: Always wear safety glasses. Always wear
respiratory protection. Always wear hearing protection.
Use of gloves, long pants and substantial footwear is
recommended. Keep long hair and loose clothing away
from openings and moving parts.
CAUTION: Do not point unit discharge at self
or bystanders.
1. To turn the blower ON, squeeze the trigger switch
2. To turn the blower OFF, release the trigger switch
Use (Fig. E)
WARNING: Always wear safety glasses. Always wear
respiratory protection. Always wear hearing protection.
Use of gloves, long pants and substantial footwear is
recommended. Keep long hair and loose clothing away
from openings and moving parts.
CAUTION: Do not point unit discharge at self
or bystanders.
1. Hold the blower approximately 7" (180 mm) above
the ground, turn the blower ON and using a sweeping
motion from side to side, advance slowly keeping the
accumulated debris/leaves in front of you.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
16
.
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered
by D
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact D
WALT call 1‑800‑4‑D
e
visit our website: www.dewalt.com.
Repairs
The charger and battery pack are not serviceable. There are
no serviceable parts inside the charger or battery pack.
WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a D
17
.
D
WALT authorized service center. Always use identical
e
replacement parts.
17
.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
• Register online at www.dewalt.com
WALT, have not been tested with this product, use
WALT recommended
e
WALT (1‑800‑433‑9258) or
e
WALT factory service center or a
e
English
7
Tabla de contenido
