DWT SDS21-355 DN Manual Original página 20

• Keep the handle of the power tool clean and free of
oil to control the power tool and to make the operation
safe�
During operation
• Never stand on the power tool - if it turns over or
if you accidentally touch the cutting disc, you can be
seriously injured�
• Keep your hands at a safe distance from the cutting
disc�
• During operation stand aside from the plane of
rotation of the cutting disc�
• During operation watch the position of a power cable
(it should always be positioned behind the tool)� Do not
allow it to whip around your legs or arms�
• Never start cutting until the cutting disc reaches its
full speed�
• Always process only one blank - this is the only way
to fix it properly.
• While processing long blanks use the clam ping
devices and be sure to provide a support under the
long end of the blank� Never make a third person hold
the working blank�
• Never remove blank waste-ends while the power
tool motor is running�
• If during operation the cutting disc gets stuck in the
blank or is blocked by the waste-ends, immediately
switch off the power tool and only then eliminate the
cause of the cutting disc failure�
• Dust generated during operation may be a hazard
to your health, inflammable or explosive; clean your
working place in time and use means of individual
protection�
• Operation may produce sparks and small metal
particles, which can cause injury to the operator or
to the bystanders� Always wear means of individual
protection (goggles and protective mask), as well as
arrange your working place in a proper way�
• Do not work materials containing asbestos�
Asbestos is considered carcinogenic�
• It is not allowed to use the power tool for cutting
workpieces made of magnesium or its compounds�
• Avoid stopping the power tool motor when under load�
• Avoid overheating your power tool, when using it for
a long time�
After finishing operation
• The power tool can be removed from the workplace
only after the cutting disc has been switched off and
stopped completely�
• Never try to slow down the inertial rotation of the
cutting disc with the spindle lock or by applying effort
to the cutting disc lateral surface� If you use the spindle
lock for this purpose, the power tool will fail and your
warranty will be cancelled�
• The cutting discs can get very hot during operation -
do not touch them until they have cooled down�
Symbols used in
the manual
Following symbols are used in the operation manual,
please remember their meanings� Correct interpretation
of the symbols will allow correct and safe use of the
power tool�
Symbol
English
20
Meaning
Cut-off saw
Sections marked gray - soft
grip (with insulated surface)�
Serial number sticker:
SDS��� - model;
XX - date of manufacture;
XXXXXXX - serial number�
Read all safety regulations
and instructions�
Wear safety goggles�
Wear ear protectors�
Wear a dust mask�
Wear protective gloves�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Prohibited�