Steren INV-300 Manual Del Usuario página 6

Please, place the inverter as close as possible to the battery, in
order to get the best performance.
d) Grounding the inverter (Only INV-1000)
Do not install the inverter in a positive ground DC system.
To identify a positive ground DC system, look for the positive
terminal of the battery connected to the chassis or to a central
grounding point.
e) Connecting to a power source
Usually, the power source is a battery (or group of batteries)
which is recharged by an alternator.
1.- Make sure the inverter's power switch is on OFF position and
there are no liquids near of it.
2.- Connect the eye-type terminals (supplied with the inverter).
Place the black cable in the middle of the negative connector (-),
and place the red cable in the positive connector (+).
3.- Tighten the screws fi rmly to hold the cables.
4.- Use the red alligator to connect it to positive end (+) in the
power source.
5.- Use the black alligator to connect the inverter to power
source's negative end (-).
6.- Turn the inverter on. The indicator light and the surge
indicator will light up.
7.- Turn the inverter. The installation fi nished.
If the polarity is inverted, may cause several and permanent If the polarity is inverted, may cause several and permanent
damages in the inverter. damages in the inverter.
You will watch some sparks when connect the battery to the You will watch some sparks when connect the battery to the
inverter. inverter.
Make sure there are not fl ammable liquids near the inverter, Make sure there are not fl ammable liquids near the inverter,
may cause an explosion. may cause an explosion.
ENGLISH-6