BelFox Premium Slider 500 Manual De Instrucciones página 49

When carrying out the installation work, the competent person must comply
with all relevant and applicable regulations on occupational safety and the re-
gulations for the operation of electrical equipment. National occupational sa-
fety regulations, accident prevention regulations and valid standards of the
respective country must be observed and complied with! When installing the
drive, possible hazards in the sense of EN 13241-1 and EN 12453 must be ob-
served.
The guideline "Technical rules for workplaces ASR A1.7" of the committee for
workplaces (ASTA) is valid in Germany for the operator and must be observed
and complied with.
1 1 0 0 . . C C h h e e c c k k i i n n g g t t h h e e g g a a t t e e / / p p r r e e p p a a r r i i n n g g t t h h e e g g a a t t e e s s y y s s t t e e m m
Risk of injury due to faults in the door system!
A faulty door system or incorrectly aligned doors can lead to serious injuries
and damage.
SAFETY INSTRUCTION FOR HAZARD AVOIDANCE
x Do not use the door system if it needs to be repaired or reset.
x Check the entire door system for possible damage and wear before in-
stallation!
x
Check for corrosion, rust or cracks.
The drive is not designed for the operation of heavy gates. Sluggish doors are
doors that are difficult or impossible to open and close manually. The door run
must not have any incline or decline.
The operator is designed for smooth-running gates that are in a mechanically
fault-free condition and easy to operate by hand (EN 12604). The operator is
suitable for both floor-guided and cantilevered sliding gates.
x Check that the door can be opened and closed completely, correctly and
smoothly.
x Mechanically secure the door against running out of its guides.
WARNING
15