Hardwired Installation - Wallbox PULSAR PLUS Manual De Usuario

EN
INSTALLATION

Hardwired installation

Installation of your Wallbox charger with a permanent power supply
Bottom Rear
Connection Connection
Power supply/wiring
Follow our recommendations
for location and positioning
the charger in page 8.
Make sure to power off any connections!
12
Determine wiring entry
Before hardwire installation, determine which
entry port you will be using for your power
supply wiring or conduit. Your charger can be
connected from either the rear or bottom entry
ports. Choose the most appropriate connection
based on the placement of your wiring or
conduit.
Be sure to note that the power supply entry for
either port will be on the left side of your charger.
Ensure that you locate your charger so that the
power supply wiring or conduit is accessible on
the left side of your charger.
Placement
Using a wall stud finder, find the wall stud
nearest to and on the right side of the power
supply wiring.
Mark a vertical line approximately 20" (50cm)
in length in line with the wall stud at the
approximate height of your mounting.
Alternately you may find a suitable location on
a solid wall.
Preparing your charger
Hardwire installation requires opening your
charger to access and connect the hardwire power
supply connection.
• Remove the cover frame from the front of your
charger by removing the bottom screw that
affixes the frame to the cover.
• Remove the four corner screws on the cover and
carefully lift the cover.
• From the cover, carefully detach the ribbon
cable. Set the cover aside.
T20
ø4 x 10mm
INSTALLATION
Hardwired installation
The rear/bottom aperture has a diameter of 1 1/4"
(3.25cm), therefore a 1" conduit fitting is recommended.
For rear wiring installation, draw the power supply
wiring through the hole in the wall and then through the
rear port of the wallplate before mounting the wallplate.
Removing the NEMA
14-50P cable
40A NEMA Model only
1.
To disconnect the NEMA power cable wiring,
unscrew the terminal screws as shown in the
diagram on the left.
2.
Loosen the left cable gland in a counter-
clockwise direction and pull down on the NEMA
cable to release it from your charger.
Safely store or dispose of the NEMA cable.
For rear wiring installations
Use a small screwdriver to cut a slit in the rubber
grommet to create an opening for your power
supply wiring. Alternately, if you are using conduit
for the rear attachment, remove the grommet and
attach the conduit fitting.
• For 40A model rear wiring installations, remove
the bottom cable gland and attach the provided
screw plug to cover the bottom port.
For bottom wiring installations
Remove the attached cable gland (40A model) or
screw plug (48A model) to allow the attachment of
the conduit fitting.
Installing the wallplate
1.
Remove the tape from the wallplate to detach
it from the charger.
2.
Place the wallplate with the center holes
aligned with the vertical line drawn earlier.
Mark the location of the holes.
For rear wiring installation, also mark
the location of the rear power entry port.
3.
Drill two holes with an appropriate sized bit.
Place the wallplate in alignment with the holes
and firmly mount the wallplate using the provided
wall screws. Do not over-tighten the screws.
• If you are mounting your charger on a solid
wall, use the wall anchors provided with your
charger.
x2
x2
13
EN