System Components - Uline NewAir Flex H-7259 Manual Del Usuario

SYSTEM DESCRIPTION
The H-7259 Instant Bubble Roll Machine creates
on-demand, air-filled cushioning material from a
compact/uninflated pre-formed roll of material. The
inflated material chain is perforated into sections and
can easily be separated by the operator as needed.
There are three modes of operation:
MANUAL MODE
• Press start key to begin producing material and the
stop key to end production.
BATCH MODE
• Dispense a programmed length of material.
ROLL WINDER MODE
• Requires optional roll winder (H-7283) and stand
(H-7284).
• Dispense a roll of inflated material.
1. ON/OFF Power Switch
Switch controls power to system and is located on
back of machine.
2. Emergency Stop Switch (E-Stop)
Switch stops all feeding, inflating and sealing functions.
3. Main Power Cord
Plug into a properly rated receptacle. See Electrical
Power Requirements above.
4. Control Panel
This panel with LCD display and keys is used to operate,
program and diagnose the system. See Operation on
page 5.
PAGE 2 OF 30
OVERVIEW

SYSTEM COMPONENTS

2
4
6
ELECTRICAL POWER REQUIREMENTS
WARNING! Use of extension cord will increase
the levels of static, resulting in operational
problems.
Inflatable Cushioning System: 115 VAC
Receptacle Type: NEMA 5-15R
A/C Voltage: 100-120 VAC 50/60 Hz
Phase: Single Phase Grounded
Current: 15A Service 4.0A
NOTE: The use of non-compatible materials will
cause production problems, may damage the
equipment and will reduce the quality of the
packaging protection.
1
3
7
8
5. Material Mandrel
This mount provides an unwind position for the material
roll.
6. Edge Seal Assembly
This replaceable component wheel creates an edge
seal, sealing air in the material. See Replacing the
Edge Seal on page 7.
7. Air Pump
Provides air to fill bubble material.
8. Tray Kit
Allows machine to sit on tabletop.
5
0521 IH-7259