Uline H-4018 Manual De Instalación
Ocultar thumbs Ver también para H-4018:
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-4018
SHRINK TUNNEL
WARNING! Do not operate machinery without
all safety guards and covers securely in place.
The mechanical operation of automatic
equipment involves many moving parts and
pinch points that could cause bodily harm.
WARNING! Keep hands away from all moving
assemblies.
Do not wear gloves or other apparel that may
get caught in moving parts. Wear appropriate
protective apparel.
Worn parts can become hazardous and
should be replaced promptly. It is the user's
responsibility to be aware of and address
damaged parts and maintenance items.
UNCRATING
1. Remove the shipping crate from the pallet, being
careful not to strike or pry against Shrink Tunnel.
2. Carefully cut the bands that hold the tunnel to the
pallet.
3. Inspect the tunnel for shipping damage.
PAGE 1 OF 14
1-800-295-5510
uline.ca
WARNINGS
INSTALLATION AND SETUP
Pour le français, consulter les pages 10-14.
WARNING! Heat-shrinking equipment can get
very hot. Keep hands away from heat source
while machine is in operation, and use caution
if the machine has been recently used.
SETUP
NOTE: The tunnel is not fastened to the conveyor.
Lift the tunnel by the conveyor.
1. Move the tunnel to its final location before removing it
from the pallet.
2. Connect the conveyor cord to a properly grounded
110-volt outlet with a minimum capacity of 5 amps.
Para Español, vea páginas 5-9.
0721 IH-4018
Tabla de contenido
loading

Resumen de contenidos para Uline H-4018

  • Página 5: Instalación Y Configuración

    H-4018 1-800-295-5510 uline.ca TÚNEL TERMOENCOGIBLE ADVERTENCIAS ¡ADVERTENCIA! No ponga en marcha esta Las piezas desgastadas podrían ser peligrosas máquina sin todas las cubiertas colocadas y deben reemplazarse lo antes posible. Es en su lugar y los protectores de seguridad. responsabilidad del usuario estar al tanto de El funcionamiento mecánico de equipos...
  • Página 6 CONTINUACIÓN DE INSTALACIÓN Y CONFIGURACIÓN INICIO DE LA BANDA TRANSPORTADORA NOTA: El ventilador de la resistencia debería iniciar al encender el interruptor de palanca. El 1. Encienda la banda transportadora con el interruptor ventilador hará algo de ruido y las cortinas se ON / OFF.
  • Página 7: Instalación Y Configuración Del Kit De Patas Opcional

    INSTALACIÓN Y CONFIGURACIÓN DEL KIT DE PATAS OPCIONAL ¡PRECAUCIÓN! Montar el kit de patas a la 4. Atornille las patas en los orificios roscados incluidos en banda transportadora puede ser peligroso. la parte inferior de la repisa. Inserte las ruedas en el inserto de nylon junto a las patas.
  • Página 8: Solución De Problemas

    SOLUCIÓN DE PROBLEMAS ¡PRECAUCIÓN! Las pruebas eléctricas y las ¡PRECAUCIÓN! A menos que un procedimiento tareas de mantenimiento solo deberán ser establezca específicamente que la máquina llevadas a cabo por personal calificado. debe estar encendida para llevar a cabo las pruebas necesarias, deberá...
  • Página 9: Continuación De Solución De Problemas

    Verifique que no haya fugas de aire, especialmente alrededor de la cubierta del ventilador. Verifique el estado de las cortinas. 1-800-295-5510 uline.ca PAGE 9 OF 14 0721 IH-4018...

Tabla de contenido